Starter Triangle for Chevron Panels (Peel and Stick)
Creating a chevron panel on any vehicle is relatively simple. You find dead center, mark it with a line top to bottom, and then apply a triangle with 45 degree angled sides to the center at the bottom. From that point on you simply apply alternating colors and trim.
On this page we have our precut starter triangles. They are cut from Orafol/Reflexite V98 material which is the same material we use for all of our rolls and panels on this site. To use them you simply peel, stick and press on with a soft cloth or rubber squeegee. Our starter triangles measure 5.5" tall and about 11" wide at the base. The angles are exactly 45 degrees to meet NFPA 1901 standards. Along with the triangle you would need to purchase 6" V98 Chevron Striping in fluorescent lime and red. With these items you would have all you need to create vivid, reflective chevrons on your vehicles or trailers.
Shipping is FREE on this item. When ordered with other items you will pay only the shipping on the other item.
Our starter triangles are available in red and fluorescent lime. They are priced at $10 each with no additional shipping. You can make your quantity and color choice above using the drop down menus. (they match our V98 chevron striping rolls on this site exactly)